Archives

In any indoor environment, lighting plays a crucial role in the productivity, concentration and well-being of occupants. Good lighting can boost energy, improve mood and reduce eyestrain. Measuring brightness is therefore essential to guarantee the visual comfort, safety, energy efficiency and functionality of interior spaces.

To secure the product with the FIX adhesive fastener :   Place the adhesive on the mounting base and press firmly with your fingers for 10 seconds. Remove the adhesive backing and stick the mounting base to the wall or ceiling. Press down hard with your fingers for 10 seconds and wait 30 seconds before […]

To secure the base to the wall or ceiling: Use a level to draw a line about 5 centimetres wide on your wall. Position the base on the line with the “UP” marking and the arrows pointing upwards. The small ears on either side of the base should be on the lower edge of the […]

Ceiling or wall installation Install the detector on the ceiling in the center of the room, at least 50 cm from corners, walls, beams or any other obstacle. Install the detector on the wall at a distance of between 50 cm and 60 cm below the ceiling. Fixing to a sloping ceiling Install the detector […]

Sealed-battery detector Follow the commissioning procedure for INSAFE and INSAFE+, ORIGIN and ORIGIN+ detectors: Switch on single-use switch (1) Wait a few seconds, then press the detector button for 3 seconds until the alarm sounds, then release to stop the alarm (2) The detector initializes for 10 minutes. After 10 minutes, the detector is ready […]

Every year, clean the detector and perform an alarm test: Remove the detector from its base Turn the detector over Remove dust with the brush attachment of a vacuum cleaner, sucking for 30 seconds (any insects, spider webs or dust clusters near the detector must be removed). Press the Test / Silence button until the […]

Every year, test the detector to ensure that the light and sound indicators are working properly.

Depending on the configuration and surface area of your home, you may need several smoke detectors to ensure minimum protection, effective detection, alarm range and rapid evacuation. Standard installation one detector per floor in corridors and/or stairwells between sleeping areas (bedrooms), possible sources of fire (garage, electrical installation, etc.) and exits from your home (door, […]

For your safety, please observe the following points: Comply with all the instructions in this manual, and be aware that failure to replace your detector when the user manual specifies, pausing the detector and stopping an alarm can be dangerous. Do not install the detector in one of the “Locations to avoid”. Do not paint, […]

Depending on the model chosen, your detector has the following functions: INSAFE, smoke detector INSAFE+, smoke detector with NFC chip ORIGIN, connected smoke detector ORIGIN+, connected smoke detector, temperature and humidity sensors GUARD, connected smoke detector with changeable battery GUARD+, connected smoke detector with changeable battery, temperature and humidity sensors

A smoke detector is an alarm system designed to trigger an early warning in the event of a fire, thanks to its built-in sound system. The products are Autonomous Smoke Detectors (ASD) for domestic use. EN14604:2005/AC:2008 certification: The full text of the declaration of conformity is available on support.nexelec.fr The CE mark affixed to this […]

Your smoke detector features a red indicator light on the front panel, plus a Test/Silence button. On the back of the product you’ll find the settings button and LED, as well as the battery cover. If your detector is fitted with a sealed 10-year battery, the battery door is locked.